Anilam Wizard 211 - Page 41

37
Parameter Settings – F 20 (Continued)
The DRO displays the following in the selected axis display(s):
X .005
Coarse Resolution
Symbol
ABS
MM
This setting is for the resolution of the axis display(s) when you have toggled the
MM/INCH key to MM mode only. The axis designation is blinking indicating that you can
enter a value. The DRO will default the same display resolution as the encoder
resolution (in this example, .005 MM). ANILAM recommends that you use the same
display resolution as the encoder resolution.
7. Press
+
_
to scroll through the display
resolution options.
The display resolution options for MM mode are:
.0002, .0005, .001, .002, 005, .01, .02, .05, .1, .2, .5 MM
NOTE: If the selected display resolution is coarser than the encoder resolution, the
DRO turns on the Coarse Resolution Symbol in the axis display(s).
8. Press
to select the desired display
resolution in MM mode.
The DRO displays the following in the selected axis display(s):
X .0002
Coarse Resolution
Symbol
ABS
INCH