Copyright © 2019 ANK Audio Kits
www.AudioNoteKits.com
audionotekits@rogers.com
Page 95
11.2 Installing the Fuse
Tubes Installed At This Point: None
Let's start by installing a 1A
14
Slo-Blo fuse from the IEC bag.
If the fuse holder is already installed in the IEC plug, use a screwdriver, a flat edge, or your
fingers to pull it out; you may need to squeeze it to completely remove it.
Install the fuse in the small plastic fuse holder and insert it into the IEC. (You can ignore any
lettering like '240V only' — there is only one fuse holder type for all world voltages.)
Turn the amplifier on. If the fuse does not blow, continue to the next step. If it does, jump ahead
to "Debugging." Turn the amplifier off.
14
If all is well you can change to a 2A fuse.
To Next Page
