Copyright © 2019 ANK Audio Kits
www.AudioNoteKits.com
audionotekits@rogers.com
Page 35
2.12 Installing the Choke
Let's continue by installing the Choke. This is quite straightforward.
Neatly lay out the necessary hardware close at hand:
4 M4 screws
4 M4 washers
4 M4 Keps K-Lock Nuts (these are M4 nuts with attached locking washers)
Install the Choke as shown below:
Congratulations on completing the mechanical assembly and initial Power Supply wiring! Now we'll
move onto the Power Supply board.
To Next Page
