Syn tax: CONT
Re marks: This com mand will al low the sys tem to con tinue the startup se quence if
there are self test fail ures other than DSP er rors.
Re lated
Com mands: STERR, START
CUR Cur sor in Power vs. Time and Source Sweep modes
SYS TEM
Syn tax: CUR <cur sor>,<fval>
cursor: 1 or 2
fval: 0.0 to 1440 min utes (24 hours) in Power vs. Time mode
In Source Sweep mode, Power sweep : –120.0 dB to 30.0 dB
In Source Sweep mode, Fre quency sweep : 10.0 KHz to 122.0 GHz
Re marks: In Power vs. Time mode, the fval pa ram e ter is in min utes. In Source
Sweep mode, the fval pa ram e ter is in dB or Hz for a power sweep or fre -
quency sweep respectivily.
Ex am ples:
Power vs. Time:
Set cur sor 1 to 30 sec onds: CUR 1,0.5
Set cur sor 2 to 12.5 hours: CUR 2,750
Source sweep:
Power Sweep, set cur sor 1 to 11.5 dB: CUR 1,11.5
Fre quency Sweep, set cur sor 2 to 15.6 GHz: CUR 2,15.6GHz
Re lated
Com mands:
GRDDT, SRCSPFRQ, SRCSTFRQ, SRCSTPWR, SRCSPPWR
CURLK Link cur sors in all graphic modes
PRO FILE SETUP
Syn tax: CURLK <state>
state: ON
OFF
Re marks: Links the two cursors to gether on the graph. When ei ther cur sor moves
left or right, the other cur sor fol lows. Sub se quent changes to de lay will
move both cursors.
Query: CURLK?
Re turned
String: CURLK <state>
6-30 ML2400A OM
ML24XXA NATIVE COMMANDS GPIB OPERATION
To Next Page
Loading...
