PRINT Send de tails to the con nected printer. SYS TEM
Syn tax: PRINT
Re marks: The type of print out de pends on the op era tion mode cur rently se lected.
In all modes, the print out in cludes a header with the cur rent sen sor set -
tings and meas ure ment chan nel set ups.
When in Read out mode, the Chan nel 1 and Chan nel 2 val ues, and the
max/min val ues if pres ent, are printed be low the header.
In Pro file and Power vs. Time modes, a graph is printed out be low the
header with all the de tails shown.
PRNSEL Se lect the type of printer
SYS TEM
Syn tax: PRNSEL <type>
type: HP340
BJC80
Re marks: Avail able printer se lec tions are the HP DeskJet 340 and Canon BJC80.
Other 300, 500, 600 Se ries and later HP print ers are typ i cally com pat i -
ble. If the Canon BJC80 printer is se lected, it must be set to EPSON LQ
em u la tion mode for proper op er a tion. Re fer to the printer man ual for in -
struc tions on set ting the em u la tion mode.
Query: PRNSEL?
Re turned
String: PRNSEL <printer>
RCD Range Cali bra tor data request
DATA OUTPUT
Syn tax: RCD <s>
s: A or B
Re marks: Returns the results from an ML2419A Range Cali bra tor run af ter the
Range Calibrator is disconnected from the power me ter. While still
connected to the Range Cali bra tor, the results can be printed but not
read via GPIB. The re sults in clude val ues for each end of each sensor
range and the zero value, and are kept in non- volatile memory until the
Range Calibrator is connected and a calibration run again.
Re sponse for mat:
'RCD<ws><sen sor>,<state>[,<zero value>,<range 1 up per>,<range
1 lower>,........]'
6-68 ML2400A OM
ML24XXA NATIVE COMMANDS GPIB OPERATION
To Next Page
Loading...
