store
number: 1 to 10
data
length: num ber of bytes of bi nary data
bi nary
data: Saved data pre vi ously read from the me ter us ing the SYSRD com mand
Re marks: Sets the passed store num ber to the setup con tained in the bi nary data
that was ex tracted us ing the SYSRD com mand. When re call ing a setup
in volves the read out mode chang ing be tween STAN DARD and CDMA,
the in stru ment will re boot.
Re lated
Com mands: SYSRD
SYSLNM Saved set naming
SYSTEM
Syn tax: SYSLNM <store num ber>,<text>
store
number: 1 to 10
text: text string
Re marks: This com mand al lows the saved set ups to have text as so ci ated with
them rather than just the ‘USED’ and ‘NOT USED’ text.
Query: SYSLNM? <store num ber>
Re turned
String: SYSLNM <store num ber>,<store name>
If a store num ber of 0 is used, then all the store ti tles will be out put in
the form:
SYSLNM 1,<store 1 name>,2,<store 2 name>, … ,10,<store 10
name>
SYSRD Out put the saved setup over the GPIB
DATA OUT PUT
Syn tax: SYSRD <store number>
store
number:
0 (cur rent setup) or 1 to 10 saved stores
Re marks: Re quests that the saved stored setup is out put over the GPIB. This is a
BI NARY out put that al lows the stored setup to be pro grammed into
other ML2400A Se ries power me ters and stores via the SYSLD com -
mand. If a re quest for a store number that has not had a setup stored
into it is made, an execution error event will be set in the Event Status
Reg is ter (ESR).
ML2400A OM 6-77
GPIB OPERATION ML24XXA NATIVE COMMANDS
To Next Page
Loading...
