Re marks: Se lects the cal fac tor ta ble to be used.
SM status mes sage
Syn tax: SM
Re marks: Re turns the status mes sage in the for mat:
AAaaBBCCccDDddEF GHIJKLM NOP<cr><lf>
where:
AA: meas ure ment er ror code
aa: en try er ror code
BB: op er at ing mode
CC: sen sor A range
cc: 0
DD: sen sor A fil ter
dd: 0
E: lin ear/log units
F: A
G: pwr ref status
H: REL mode status
I: trig ger mode
J: group trig ger mode
K: lim its check ing status
L: sen sor A lim its status
M: 0
N: off set status
O: duty cy cle status
P: meas ure ment units
SN Cal ta ble iden tity up date
Syn tax: SN<val>
val: up to seven characters
Re marks: Since the ML2400A stores the cal factor table information in the sensor,
this data must be saved to the sensor by using the ‘EX’ command or an
additional command ‘SV’, or the data could be lost. The saving of the cal
factor table data to the sensor can be done at the end of all updates to a
particular table.
ST Store setup
Syn tax: ST<val>EN
val: 1 to 10
ML2400A OM 6-117
GPIB OPERATION HP 437B EMULATION COMMANDS
To Next Page
Loading...
