Re marks: Stores the pres ent con figu ra tion to the se lected reg is ter.
Ex am ple: To store the cur rent in stru ment con figu ra tion in reg is ter 2:
ST2EN
Re lated
Com mands: RC
SV Save cal fac tor table
Syn tax: SV
Re marks: Since the ML2400A stores the cal factor tables in the sensors, this
command forces the edits to a cal factor table to be saved to the sensor.
The operation can take a couple of seconds to complete.
TR0 Trig ger hold mode
Syn tax: TR0
Re marks: Sets both chan nels to trig ger hold mode. It does not trig ger un til it re -
ceives a TR1 or TR2 or GET (group ex ecu tive trig ger), *TRG or TR3
com mand. If it re ceives a TR3 com mand it re verts back to the trig ger
mode it was in be fore the TR0 com mand was sent. If the REM line is
low, this com mand has no ef fect.
Re lated
Com mands: TR1, TR2, TR3, *TRG, Group Exe cute Trig ger (GET), GT0, GT1, GT2
TR1 Trig ger im me di ate
Syn tax: TR1
Re marks: Trig gers a sin gle read ing which is added to the in ter nal digi tal fil ter and
the up dated fil ter power level is re turned on the GPIB. Af ter a TR1 com -
mand, the in stru ment re turns to TR0 standby mode.
Re lated
Com mands:
TR0, TR2, TR3, *TRG, Group Exe cute Trig ger (GET), GT0, GT1, GT2
TR2 Trig ger with a set tling de lay
Syn tax: TR2
6-118 ML2400A OM
HP 437B EMULATION COMMANDS GPIB OPERATION
To Next Page
Loading...
