Anritsu ML2400A Series - Page 229

A-4 ML2400A OM
SYSTEM SPECIFICATIONS APPENDIX A
Se cure Mode: Erases mem ory in for ma tion upon power ON. De fault
con di tion is Se cure Mode OFF.
Rear Panel In puts/Out puts
Cal Fac tor
Volt age
In put
(BNC):
Op er at ing Modes:
Volt age: Dis play volt age read ing on se lected chan nel.
Volt age pro por tional to fre quency for sen sor cali bra -
tion fac tor com pen sa tion.
Blank ing In put: TTL lev els only. Se lecta ble posi tive
or nega tive po lar ity.
In put Range:
0 to 20V
Reso lu tion: 0.5 mV
Con trol: Ad just able volt age to fre quency rela tion ship
Ana log
Out put
(BNC):
Two out puts con fig ur able to Log or Lin
Op er at ing
Modes:
Ana log Out: Se lecta ble chan nel ad justed for cali bra -
tion fac tors and other power read ing cor rec tion set -
tings.
Pass/Fail: Se lecta ble TTL High or Low
Chan nel out put: Near real time an a log, uncalibrated.
AC Modu la tion Out put: Out put 1 only.
Out put
Range:
–5.0 to 5.0V
Reso lu tion: 0.1 mV
Trig ger In put:
Op er at ing
Modes: Ex ter nal TTL or RF Blank ing.
GPIB In ter -
face:
IEEE- 488.2 and IEC- 625 . Im ple ments AH1, SH1, T6,
LE0, SR1, RL1, PP0, DC1, DT1, C0 and E1.
RS232: Sup ports soft ware down load and GPIB commands.
Par al lel
Printer
Out put:
Com pati ble with HP Desk jet 540 and 310 Models,
and the Canon BJC80. Other 300 , 500, 600 Se ries
and later HP print ers are typi cally com pati ble. See
printer man ual for DIP switch set tings.