Anrtisu Site Master S331D - All Modes; Save and Recall a Setup; Save and Recall a Display; Interference Analysis

1-8
Chapter 1 General Information
High Accuracy Power Meter (Option 19, with PSN50 Power Sensor)
Sensor:
Measurement Range: –30 to +20 dBm
Frequency Range: 50 MHz to 6 GHz
Input Connector: Type N, male, 50W
Max Input Without Damage: +33 dBm, ± 25 VDC
Input Return Loss : 50 MHz to 2 GHz: ³26 dB
2 GHz to 6 GHz: ³20 dB
Accuracy:
Total RSS Meas. Uncertainty: CW signals: ± 0.16 dB (0 to 50°C)*
Noise: 20 nW max
Zero Set: 20 nW
Zero Drift: 10 nW max**
Instrumentation Accuracy: 0.00 dB
Sensor Linearity: ± 0.13 dB max
Sensor Cal Factor Uncertainty: ± 0.06 dB
Temperature Compensation: ± 0.06 dB max
Continuous digital modulation uncertainty:
+0.06 dB (+17 to +20 dBm)
System:
Measurement Resolution: 0.01 dB
Offset Range: ± 60dB
Power Requirements:
Supply Voltage: 8 to 18 Vdc
Supply Current: <100 mA
*Excludes mismatch errors. Excludes noise, zero set, zero drift for levels <-20 dBm. Excludes digital modula
-
tion uncertainty between +17 and +20 dBm.
**After 30 min warm-up
Transmission Measurement (Option 21)
RF Source:
Frequency Range: 25 MHz to 3 GHz
Frequency Resolution: 10 Hz
Output Power Level: –10 dBm typical
Dynamic Range: 80 dB, 25 MHz to 2 GHz
60 dB, >2 GHz to 3 GHz
Output Impedance: 50W
Interference Analysis (Option 25)
Audible tone - identify interference type
Strength of the Interferer
RSSI
Spectrogram
Table 1-1. Performance Specifications (3 of 6)