Anrtisu Site Master S331D - Page 46

q
Marker To Peak — Places the selected marker at the frequency or dis
-
tance with the maximum amplitude value.
q
Marker To Valley — Places the selected marker at the frequency or dis
-
tance with the minimum amplitude value.
q
Back — Returns to the Main Markers Menu.
q
All Off — Turns all markers off.
q
More — Opens the continuation of the Marker Menus.
q
M5 — Selects the M5 marker parameter and opens the M5 second level
menu.
q
On/Off — Turns the selected marker on or off.
q
Edit — Opens the selected marker parameter for data entry. Press
ENTER when data entry is complete or ESCAPE to restore the pre
-
vious value.
q
Peak Between M1 & M2 — Places the selected marker at the fre
-
quency or distance with the maximum amplitude value between
marker M1 and marker M2.
q
Valley Between M1 & M2 — Places the selected marker at the fre
-
quency or distance with the minimum amplitude value between
marker M1 and marker M2.
q
Back — Returns to the Main Markers Menu.
q
M6 — Selects the M6 marker parameter and opens the M6 second level
menu.
q
On/Off — Turns the selected marker on or off.
q
Edit — Opens the selected marker parameter for data entry. Press
ENTER when data entry is complete or ESCAPE to restore the pre-
vious value.
q
Peak Between M3 & M4 — Places the selected marker at the peak be-
tween marker M3 and marker M4.
q
Valley Between M3 & M4 — Places the selected marker at the valley
between marker M3 and marker M4.
q
Back — Returns to the Main Markers Menu.
q
All Off —Turns all markers off
q
Back — Returns to the Main Markers Menu.
Choosing MARKER in Spectrum Analyzer mode causes the soft keys, below, to
be displayed and the corresponding values to be shown in the message area.
q
M1 — Selects the M1 marker parameter and opens the M1 marker second
level menu.
q
On/Off — Turns the selected marker on or off.
q
Edit — Opens the selected marker parameter for data entry. Press
ENTER when data entry is complete or ESCAPE to restore the previous
value.
q
Marker To Peak — Places the selected marker at the frequency with the
maximum amplitude value.
q
Marker Freq To Center — Makes the center frequency of the Site Master
equal to the frequency of the selected marker.
Chapter 2 Functions and Operations
2-25