In Profile Mode, the Quantum displays the following information (see figure 10):
a. Profile number: This is the sequential number of the dive in memory.
b. Dive time: This is the minute display during the dive. If the profile recording
was set to 30 seconds, you will see two depth readings for each minute; if set to
15 seconds, you will see four depth readings per minute.
c. Depth: The depth where the sampling occurred.
d. Date: The date the dive was made.
e. Mix: The mix setting used during the dive.
f. Water Type: The water type setting when the dive was made.
g. NITROX indicator: If the FO
2
was set to 22% or higher, the nitrox indicator is
displayed.
To Next Page
Loading...
