Set Time Mode
The Quantum records the time and date of each dive into memory; therefore, it is
important to make sure that the time and date are set correctly. Remember to set the
time after changing the battery or traveling to a different time zone.
To enter the Set Time Mode, press MODE until SET is displayed at the bottom of the
screen.
The buttons operate as follows:
1. Press B to change a setting. Press and hold B to rapidly scroll through the set-
tings.
2. Press A to move to the next field.
3. Press MODE to save the settings and exit the mode.
The settings are listed below in the order that you can change them (see Figure 12).
The setting that is being changed will flash.
a. Seconds: Pressing the B button will reset the seconds to 00. If the seconds
setting is 30 or higher when the button is pressed, it will also increment the
minutes setting by one.
b. Minutes.
c. Hours.
To Next Page
Loading...
Need help?
General
