Figure 5-26
5.5.1 HDD Management
Here is for you to view and implement hard disk management. See Figure 5-27.
You can see current HDD type, status, capacity and record time.
You can select HDD mode from the dropdown list such as read-only or you can erase all data in
the HDD.
Please note system needs to reboot to get all the modification activated.
Figure 5-27
Click alarm set button, the interface is shown as below. See Figure 5-28(This interface is just like
the abnormity setup). Please refer to chapter 5.5.2 for detail information.
Please highlight icon
to select the corresponding function.