APS APS-3000P Series - Installation Instructions

CHAPTER 1
INTRODUCTION
Entire Contents Copyright  2004 by Adaptive Power Systems, Inc. (APSI) • All Rights Reserved • No reproduction without written authorization from APSI.
APS-3000P Series 1 - 6 OM-001-03000-00P-03.9
Installation Instructions
Input and Output Circuit Breakers
APS-3000P Power Converter input and output circuit breakers and their connections
are on the rear of the unit. Please check to make sure all wires are connected correctly
and secured. Cooling fans, located at the rear of the unit, provide air circulation for
cooling and heat removal.
Note: It is also important to position the unit to allow easy access to the circuit breakers
on the rear of the unit.
A typical wiring diagram is shown on the following page.
AC Line Input Current Requirements
TheAC input requirement for the APS Power Converter depends on the configured AC
input voltage and total power level of the specific APS 3000 model. For three phase
AC input models, the current shown in the table below is for each phase.
Input wire sizes must be chosen to support the maximum currents shown in this table
and must conform to local electrical safety codes.
AC Line Input Current Requirements
Model
3003
3006
3009
3015
3030
3060
3090
3120
3150
3180
Input Phase
1-phase / 2-wire +
GND
3-phase
Rated Power
Total Power
3 KVA
6 KVA
9
KVA
15KVA
KVA
30KVA
60KVA
90KVA
120KVA
150kVA
180kVA
Per Phase
1 KVA
2 KVA
3
KVA
5 KVA
10KVA
20KVA
30KVA
40KVA
50kVA
60kVA
Phase
Currents
230V, 1ø
20 A
40 A
-
-
-
-
-
-
208V, 3ø
-
-
40 A
60 A
125 A
250 A
400 A
500 A
220V, 3ø
-
-
40 A
60 A
125 A
250 A
350 A
500 A
240V, 3ø
-
-
30 A
50 A
100 A
225 A
300 A
400 A
500 A
380V, 3ø
-
-
20 A
40 A
75 A
150 A
200 A
300 A
375 A
450 A
415V, 3ø
-
-
20 A
30 A
60 A
125 A
200 A
250 A
300 A
375 A
480V, 3ø
-
-
15 A
30 A
50 A
125 A
175 A
225 A
250 A
375 A