CHAPTER 4
OPERATING INSTRUCTIONS
Entire Contents Copyright 2004 by Adaptive Power Systems, Inc. (APSI) • All Rights Reserved • No reproduction without written authorization from APSI.
APS-3000P Series 4 - 23 OM-001-03000-00P-03.9
Inverter power supply voltage under-
voltage occurred during startup
Output current exceeded 110% of
maximum rated value
Output current exceeded set current
high-limit value
Output current was less than the set
low-limit value
Output power exceeded the set
high-limit value
Output power was less than the set
low-limit value
Output power factor exceeded the set
high-limit value
Output power was less than the set
low-limit value
Inverter power supply voltage was less
than 80% of the rated internal bus
voltage
Inverter power supply voltage was
greater than 120% of the rated internal
bus voltage
Input power was interrupted and then
resumed
Insulated Gate Bipolar Transistor
(IGBT) overloaded
System's critical temperature was
exceeded
Output voltage exceeded limit
Output voltage below limit
Output power exceeded limit
To Next Page
Loading...