APS APS-3000P Series - Page 54

CHAPTER 4
OPERATING INSTRUCTIONS
Entire Contents Copyright  2004 by Adaptive Power Systems, Inc. (APSI) • All Rights Reserved • No reproduction without written authorization from APSI.
APS-3000P Series 4 - 22 OM-001-03000-00P-03.9
Error messages are displayed because of the following conditions:
 Fail Under voltage occurred during startup
 OCP Output current exceeded 110% of units maximum-rated value
 Hi-A Output current exceeded the set current high limit value
 Lo-A Output current was less than the set low-limit value
 Hi-P Output power exceeded the set high-limit value
 Lo-P Output power was less than the set low-limit value
 H-PF Output power factor exceeded the set high-limit value
 L-PF Output power was less than the set low-limit value
 LoDC Inverter power supply voltage less than 80% of internal bus voltage
 HiDC Inverter power supply voltage greater than 120% of internal bus voltage
 AcLP Input power was interrupted and then resumed
 FUSE Fuse opened
 Igbt Insulated Gate Bipolar Transistor (IGBT) overloaded
 OtP System's critical temperature was exceeded
 OVP Output voltage was high
 LVP Output voltage was low
 OPP Output power was high