APS APS-3000P Series - Program Parameter Settings

CHAPTER 4
OPERATING INSTRUCTIONS
Entire Contents Copyright  2004 by Adaptive Power Systems, Inc. (APSI) • All Rights Reserved • No reproduction without written authorization from APSI.
APS-3000P Series 4 - 14 OM-001-03000-00P-03.9
Program Parameter Settings
When the system is in RESET (Standby) mode, press the PROGRAM button to enter
the Program Parameter setting mode. The PROGRAM parameter items are shown in
VOLTAGE display. The present status and values are shown in the CURRENT display
 Press the VOLTAGE ︿ or ﹀ buttons to select items for adjustment.
 Press the VOLTAGE ﹀ button to move to the next parameter item on the list.
 Press the CURRENT ︿ or ﹀ buttons to set the status and values for each item.
The Program Parameter items are presented in the following order:
 Program Selection
 Manual / AutoRUN Mode Selection
 Auto Loop Cycle
 Step Selection
 Output Voltage
 Output Frequency
 Testing Time
 Delay Decision Time
 Current High Limit
 Current Low Limit
 Power High Limit
 Power Low Limit
 Power Factor High Limit
 Power Factor Low Limit
 Connect Step
After the last item appears, the system will cycle back to the first item on the list. When
you have finished, press PROGRAM (on the CURRENT Display), to leave the
Program Parameter Setting mode.