CHAPTER 7
MAINTENANCE
Entire Contents Copyright 2004 by Adaptive Power Systems, Inc. (APSI) • All Rights Reserved • No reproduction without written authorization from APSI.
APS-3000P Series 7 - 1 OM-001-03000-00P-03.9
Chapter 7
System Maintenance
Overview
Chapter 7 describes the maintenance procedures you should perform. This is a very
short chapter because, other than keeping air filters clean, there is almost no user
maintenance required.
Introduction
No internal parts require user maintenance. If the equipment appears to have a
malfunction, please contact APS or the distributor for service (see page "v"). The
wiring and block diagram are for reference only.
Scheduled Maintenance
The APS-3000P Series Frequency Converters should be inspected and calibrated once
per year to ensure safety and accuracy of the equipment. Air vents must be kept clear
of obstructions. If the equipment is used on a regular basis in a dusty environment,
more frequent cleaning may be necessary.
Modification
Do not modify this equipment. Any modifications void the warranty automatically, and
violate the tested safety standards of the unit. APS does not take responsibility for such
equipment. Parts or accessories not certified by APS will not be covered under the
warranty. If any modification is detected in equipment returned for service, the
equipment will be returned immediately by APS and the customer will be charged for
this inspection / service.
To Next Page
Loading...