CHAPTER 4
OPERATING INSTRUCTIONS
Entire Contents Copyright 2004 by Adaptive Power Systems, Inc. (APSI) • All Rights Reserved • No reproduction without written authorization from APSI.
APS-3000P Series 4 - 1 OM-001-03000-00P-03.9
Chapter 4
Operating Instructions
Overview
Use the instructions in Chapter 4 to set up your APS-3000P Power Converter so you
can conduct tests. However, before attempting to set up your APS unit for testing, you
should be familiar with the information provided in Chapters 1, 2, and 3.
APS suggests you decide on parameter values you wish to use before turning on the
unit. There are many ways you can operate your unit. Consequently, you can begin
getting acquainted with the APS-3000P Converter by NOT attaching a load. You can
learn to select simple parameters by observing the front panel status displays.
After you are comfortable with your ability to enter operating parameters, you should
power-down completely before connecting a test load.
The information in this chapter guides you through the process of first turning on the
unit and verifying the configuration.
How Chapter 4 is Organized
Chapter 4 is organized into four sections. The information begins with what to expect
when you power-up the unit. The sequence of information in these four sections is
intended to make your use of the APS-3000P successful. The four sections are:
Basic Operation
System Parameter Settings
Program Parameter Settings
Error Messages
To Next Page
Loading...