Revision Date – 22/12/2014 page 52
9.9 Rear handle assembly – Remove and Refit
Remove the lid.
Remove and retain both hinge sockets and
screws (refer to section 9.21),
Remove and discard all 6 screw cover plugs
using the following steps.
NOTE: Removing the plugs by any other
means may result in damage to the
handle assembly.
Drill a small pilot hole in the centre of each plug.
CAUTION: Do not exceed a maximum drilling
depth of 5 mm.
Thread a self tapping screw into the centre of
each plug.
Remove each plug by pulling the screw (complete
with plug) out of the handle assembly.
HINT: Use vice grips or pliers to grip the head
of the screw.
Remove and retain the 6 screws that fasten the
handle assembly to the body of the fridge.
To Next Page
Loading...
