Arcam HDA PA720 - Rear Panel Connections and Controls PA410

EN
EN-9
POWER INLET
110-120V/220-240V ~ 50/60Hz
500W MAX
SUPPLY
VOLTAGE
SWITCH POSITIONS
115 = 110 - 120V ~
230 = 220 - 240V ~
RS232NET USB
5V 100mA
CH1
4-16 OHMS
CLASS 2 WIRING
CH2CH3CH4
IN4
OUT4
IN3
OUT3
IN2
OUT2
IN1
OUT1
TRIGGER OUT
(12V 100mA)
TRIGGER IN
POWER INLET
Connect the correct mains cable
here.
VOLTAGE SELECT
Ensure that the voltage
selected matches the local
power supply.
PRE-AMPLIFIER INPUTS
Connect the phono outputs of your
pre-amplifier.
See “Connecting Sources and
Loudspeakers” on page EN-13.
SPEAKER TERMINALS
See “Connecting Sources
and Loudspeakers” on
page EN-13.
TRIGGER IN / OUT
Trigger IN allows the PA410 to be turned on or off by an external source.
Trigger OUT allows the PA410 to control the power state of other connected
equipment
See “Trigger IN/OUT” on page EN-10.
USB
For software upgrades only. See
“USB” on page EN-10.
NETWORK
Connect your wired local network to one port.
The second port can be used to connect to
other devices
See “Network and RS232” on page EN-10.
RS232
This connection allows for remote control
from a third-party home automation
system or computer.
See “Network and RS232” on page EN-10.
Rear Panel Connections and Controls PA410
PRE-AMPLIFIER OUTPUT
OUT1 to OUT4 provide a copy
of the signal applied to the
IN1 to IN4 phono sockets.
Note: This is a passive output,
no additional filtering or
amplification is applied.
Please read the sections “Placing The Unit”,
“Power” and “Interconnect Cables” on page
EN-6 before connecting your PA410
amplier!
00_SH299_EN-FR-DE-NL-ES-RU-IT-CN-KO.indb 900_SH299_EN-FR-DE-NL-ES-RU-IT-CN-KO.indb 9 29/01/2020 13:11:3329/01/2020 13:11:33