Arcam HDA PA720 - PA720 Specifications

EN
EN-7
RS232 NET
TRIGGER OUT
(12V 100mA)
TRIGGER IN
POWER INLET
110-120V/220-240V~
50/60Hz 1.5kW MAX
USB
5V
100mA
SWITCH POSITIONS
115 = 110 - 120V ~
230 = 220 - 240V ~
SUPPLY
VOLTAGE
RCA
XLR
INPUT
IN7
OUT7
IN6
OUT6
IN5
OUT5
IN4
OUT4
IN3
OUT3
IN2
OUT2
IN1
OUT1
IN7 IN6 IN5 IN4 IN3 IN2 IN1
CH4 CH3 CH2 CH1
4-16 OHMSCLASS 2 WIRING
CH5CH6CH7
Rear Panel Connections and Controls PA720
POWER INLET
Connect the correct mains cable
here.
VOLTAGE SELECT
Ensure that the voltage
selected matches the local
power supply.
PRE-AMPLIFIER INPUTS
Connect the phono outputs of your
pre-amplifier.
See “Connecting Sources and
Loudspeakers” on page EN-13.
SPEAKER TERMINALS
See “Connecting Sources
and Loudspeakers” on
page EN-13.
TRIGGER IN / OUT
Trigger IN allows the PA720 to be turned on or off by an external source.
Trigger OUT allows the PA720 to control the power state of other connected
equipment
See “Trigger IN/OUT” on page EN-10.
USB
For software upgrades only.
See “USB” on page EN-10.
NETWORK
This connection allows for remote control
from a third-party home automation system or
computer.
See “Network and RS232” on page EN-10.
RS232
This connection allows for remote control
from a third-party home automation
system or computer.
See “Network and RS232” on page EN-10.
BALANCED XLR AUDIO INPUTS
Connect the XLR outputs of your pre-
amplifier.
See “Connecting Sources and
Loudspeakers” on page EN-13.
INPUT SWITCHES
Allow the PA720 to be configured to
different input types
See “Connecting Sources and
Loudspeakers” on page EN-13.
PRE-AMPLIFIER OUTPUT
OUT1-OUT7 provide a copy of
the signal applied to the IN1-IN7
phono sockets only, not the XLR.
Note: This is a passive output,
no additional filtering or
amplification is applied.
Please read the sections “Placing The Unit”,
“Power” and “Interconnect Cables” on page
EN-6 before connecting your PA720
amplier!
00_SH299_EN-FR-DE-NL-ES-RU-IT-CN-KO.indb 700_SH299_EN-FR-DE-NL-ES-RU-IT-CN-KO.indb 7 29/01/2020 13:11:3229/01/2020 13:11:32