7 Settings
(continued)
C232-302-401/402/403/404-603 / C232/EN M/A23 7-45
Tap changers
TAPCH: Designation TapCh 1
249 100
Fig. 3-118
Assignment of a name to the tap changer.
TAPCH: Inp.assign. TapCh 1
249 101
Fig. 3-118
Assignment of the tap changer position signal to the binary signal inputs in
BCD code. The assignment sequence proceeds from the low-value bit to
the higher value bit.
TAPCH: Lowest tap TapCh 1
249 111
Fig. 3-118
Setting for the lowest tap position for which control commands will be
operative.
TAPCH: Highest tap TapCh 1
249 112
Fig. 3-118
Setting for the highest tap position for which control commands will be
operative.
TAPCH: Oper. time TapCh 1
249 109
Fig. 3-118
Setting for the operating time for control commands.
TAPCH: Int.pos.suppr.TapCh1
249 116
Fig. 3-118
If suppression of the intermediate position is activated, then the zero
position is not transmitted while a tap change is in progress.
TAPCH: Debounce time TapCh1
249 102
Fig. 3-118
Setting for the debouncing time.
TAPCH: TapCh 1, sign
249 110
Fig. 3-118
Consideration of the sign of the tap changer.
TAPCH: Op. mode cmd. TapCh1
249 115
Fig. 3-118
The operating mode for the tap changer command can be set for long
command, short command, or time control.
TAPCH: I.asg.e.TapCh1.lower
249 117
Fig. 3-118
Assignment of the tap changing command lower to an output relay.
TAPCH: I.asg.e.TapCh1.raise
249 118
Fig. 3-118
Assignment of the tap changing command upper to an output relay.
Binary counters
COUNT: General enable USER
217 000
Fig. 3-117
Enabling or disabling the counting function.
COUNT: Debounce t. count. 1
217 160
Fig. 3-117
Setting for the debounce time of the binary signal to be counted.
COUNT: Cycle t.count transm
217 007
Fig. 3-117
Setting for the cycle time for the periodic transmission of the counts.
To Next Page
Loading...