7 Settings
C232-302-401/402/403/404-603 / C232/EN M/A23 7-1
7 Settings
7.1 Parameters
The C232 must be adjusted to the system and to the protected equipment by means of
appropriate settings. This section gives instructions for determining the settings, which
are located in the folder entitled ‘Parameters’ in the menu tree. The sequence in which
the settings are listed and described in this chapter corresponds to their sequence in the
menu tree. The 'Address List' in the Appendix lists all parameters, along with setting
ranges and incrementation or selection tables.
The units are supplied with a factory-set configuration of default settings (underlined
values in the 'Range of Values' column in the Address List). The default settings given in
the Address List are activated after a cold restart. The C232 is blocked in that case. All
settings must be re-entered after a cold restart.
All function groups and their parameters are contained in the Address List. All settings,
signals, and control commands for controlling and monitoring a switchgear unit are
included in one function group, DEVxx. The function group for the respective switchgear
unit is given in the List of Bay Types (see Appendix).
To Next Page
Loading...