6 Local Control Panel
(continued)
C232-302-401/402/403/404-603 / C232/EN M/A23 6-25
6.5.6 Memory Readout
After a memory is entered, the memory can be read out at the entry point. It is not
necessary to activate the change-enabling function or even to disable the protective
function. Inadvertent clearing of a memory at the entry point is not possible.
The following memories are available:
In the menu tree ‘Oper/Rec/OP_RC’: Operating data memory
In the menu tree ‘Oper/Rec/MT_RC’: Monitoring signal memory
Event memories
In the menu tree ‘Events/Rec/FT_RC’: Fault memories 1 to 8
In the menu tree ‘Events/Rec/OL_RC’: Overload memories 1 to 8
In the menu tree ‘Events/Rec/GF_RC’: Ground fault memories 1 to 8
Not all of these event memories are present in each unit. A given unit may contain only
some of them or even none at all, depending on the device type.
To Next Page
Loading...