9 Commissioning
(continued)
C232-302-401/402/403/404-603 / C232/EN M/A23 9-3
If either the PC interface or the communication interface will be used for setting the C232
and reading out event records, then the following settings must first be made from the
integrated local control panel.
‘Par/DvID/’ folder:
DVICE: Device password 1
DVICE: Device password 2
‘Par/Conf/’ folder:
PC: Name of manufacturer
PC: Bay address
PC: Device address
PC: Baud rate
PC: Parity bit
COMM1: Function group COMM1
COMM1: General enable USER
COMM1: Name of manufacturer
COMM1: Line idle state
COMM1: Baud rate
COMM1: Parity bit
COMM1: Communicat. protocol
COMM1: Octet comm. address
COMM1: Octet address ASDU
‘Par/Func/Glob/’ folder:
PC: Command blocking
PC: Sig./meas.val.block
COMM1: Command block. USER
COMM1: Sig./meas.block.USER
Instructions on these settings are given in Chapters 7 and 8.
Note: The settings given above apply to the IEC 60870-5-103 communication
protocol. If another protocol is being used for the communication interface,
additional settings may be necessary. See Chapter 7 for further details.
To Next Page
Loading...