ASS
97
9-11. Checking After Installation
Check that there are no gaps between the unit and
the ceiling panel, or between the ceiling panel and
the ceiling surface.
Gaps may cause water leakage and condensation.
Check that the wiring is securely connected.
If it is not securely connected, the auto flap will not
operate. (“P09” is displayed on the remote con-
troller.) In addition, water leakage and condensa-
tion may occur.
9-12. When Removing the Ceiling Panel for
Servicing
When removing the ceiling panel for servicing,
remove the air-intake grille and air filter, disconnect
the wiring connector inside the electrical component
box, and then remove the 4 mounting screws.
9-13. Adjusting the Auto Flap
The air-direction louver on the ceiling panel outlet can
be adjusted as follows.
Adjust the louver to the desired angle using the
remote controller. The louver also has an automatic
air-sweeping mechanism.
Never attempt to move the louver by hand.
Proper air flow depends on the location of the air
conditioner, the layout of the room and furniture,
etc. If cooling or heating seems inadequate, try
changing the direction of the air flow.
To Next Page
Loading...
