installation &
operating instructions
Design Envelope 4200h & 4280
End Suction Horizontal Pumping Units
24
object id object name read/write comments
Parameters
av:500 Standard mode – zero flow head Read Value for standard active mode. Unit as configured in pump control module
av:501 Standard mode – design head Read Value for standard active mode. Unit as configured in pump control module
av:502 Standard mode – design flow Read Value for standard active mode. Unit as configured in pump control module
av:503 Standard mode – minimum flow Read Value for standard active mode. Unit as configured in pump control module
av:504 Mode 1 – zero flow head Read Value for active mode 1 . Unit as configured in pump control module
av:505 Mode 1 – design head Read Value for active mode 1 . Unit as configured in pump control module
av:506 Mode 1 – design flow Read Value for active mode 1 . Unit as configured in pump control module
av:507 Mode 1 – minimum flow Read Value for active mode 1. Unit as configured in pump control module
av:508 Mode 2 – zero flow head Read Value for active mode 2. Unit as configured in pump control module
av:509 Mode 2 – design head Read Value for active mode 2. Unit as configured in pump control module
av:510 Mode 2 – design flow Read Value for active mode 2. Unit as configured in pump control module
av:511 Mode 2 – minimum flow Read Value for active mode 2. Unit as configured in pump control module
i/o
ai:0 Analog in 1 Read As configured in pump control module
ai:1 Analog in 2 Read As configured in pump control module
ao:0 Analog out 1 Read As configured in pump control module
bi:0 Digital in:1 Read As configured in pump control module
bi:1 Digital in:2 Read As configured in pump control module
bo:0 Digital out:1 Read As configured in pump control module
bo:1 Digital out:2 Read As configured in pump control module
bv:0 Relay 1 Read As configured in pump control module
bv:1 Relay 2 Read As configured in pump control module
To Next Page
Loading...
