installation &
operating instructions
Design Envelope 4322 & 4372
Tango Pumping Unit
28
object id object name read/write comments
Parameters
av:500 Standard Mode – Zero Flow Head Read Value for standard active mode. Unit as configured in Pump Control Module
av:501 Standard Mode – Design Head Read Value for standard active mode. Unit as configured in Pump Control Module
av:502 Standard Mode – Design Flow Read Value for standard active mode. Unit as configured in Pump Control Module
av:503 Standard Mode – Minimum Flow Read Value for standard active mode. Unit as configured in Pump Control Module
av:504 Mode 1 – Zero Flow Head Read Value for active mode 1. Unit as configured in Pump Control Module
av:505 Mode 1 – Design Head Read Value for active mode 1. Unit as configured in Pump Control Module
av:506 Mode 1 – Design Flow Read Value for active mode 1. Unit as configured in Pump Control Module
av:507 Mode 1 – Minimum Flow Read Value for active mode 1. Unit as configured in Pump Control Module
av:508 Mode 2 – Zero Flow Head Read Value for active mode 2. Unit as configured in Pump Control Module
av:509 Mode 2 – Design Head Read Value for active mode 2. Unit as configured in Pump Control Module
av:510 Mode 2 – Design Flow Read Value for active mode 2. Unit as configured in Pump Control Module
av:511 Mode 2 – Minimum Flow Read Value for active mode 2. Unit as configured in Pump Control Module
i/o
ai:0 Analog In 1 Read As configured in Pump Control Module
ai:1 Analog In 2 Read As configured in Pump Control Module
ao:0 Analog Out 1 Read As configured in Pump Control Module
bi:0 Digital In:1 Read As configured in Pump Control Module
bi:1 Digital In:2 Read As configured in Pump Control Module
bo:0 Digital Out:1 Read As configured in Pump Control Module
bo:1 Digital Out:2 Read As configured in Pump Control Module
bv:0 Relay 1 Read As configured in Pump Control Module
bv:1 Relay 2 Read As configured in Pump Control Module
To Next Page
