System Settings 99
WiFi Host Channel
1. Select MENU > System > Network / WiFi > WiFi Host Channel.
When using WiFi and White Radio simultaneously it is important to configure the used channels to
avoid interference and guarantee optimal performance. The following table gives an overview of
suitable channel configurations:
ARRI White Radio Channel Number
ZigBee IEEE 802.15.4 Radio Channel Number
2. Set the desired WiFi channel.
WiFi Password (Host Mode)
The camera uses WPA-2 encryption. You can only set the WiFi host password if the WiFi mode is set to
Host. The default password for the network is set to “arriarri”.
1. Select MENU > System > Network / WiFi > WiFi Host Password.
A screen is displayed to set your password.
2. Enter a password. The WiFi password must be between 8 and 32 characters long.
Connect to a Network (Client Mode)
You can select a WiFi network, if you have activated the WiFi power and when the WiFi mode is set to
Client. The camera allows you to join networks with WPA2 encryption or without encryption.
1. Select MENU > System > Network / WiFi > WiFi Network.
A list of available WiFi networks is displayed.
2. Select the WiFi network the camera should connect to.
If the selected WiFi network uses encryption, you are prompted to enter the password.
3. Enter the password and press CONNECT.
Connect to a Network using a QR Code (Client Mode)
You can use a QR code to connect to a WiFi network. The WiFi credentials need to be provided in the
following format:
WIFI:S:my-ssid;T:[WEP|WPA|WPA2];P:my-password;;
where the italic parts need to be replaced with your network credentials.
1. Select MENU > System > Network / WiFi > WiFi Network > SCAN QR.
2. Hold the QR-Code in front of the lens so that it fills the frame and is in focus.
A popup window with QR-Code data is displayed.
To Next Page
Loading...
Need help?
General
