Arturia PolyBrute - MIDI: Output Dest; MIDI: Input Src; MIDI: Arp;Seq MIDI out; MIDI: Local Control

12.8.1.2. Output Channel (upper/lower)
The pages for the upper and lower zones are identical, so both are described here.
Use [Assign 2] to return to the previous menu. Use [Assign 3-6] to make a selection. Use
[Assign 7] to confirm the choice. Turn the mod amount knob to select the desired MIDI
channel.
12.8.2. MIDI: Output dest
Use [Assign 1-4] to select the destination for outgoing MIDI data.
12.8.3. MIDI: Input src
Use [Assign 1-4] to designate the source for incoming MIDI data.
12.8.4. MIDI: Arp/Seq MIDI out
Use [Assign 1-2] to make a selection. ON sends the output of the Seq/Arp section to the MIDI
output; OFF does not send the data over MIDI.
12.8.5. MIDI: Local control
Use [Assign 1-2] to make a selection. ON enables the PolyBrute keyboard to trigger the
internal voices. OFF disconnects the keyboard from the voice engine. Use this setting to
prevent double-triggering of voices when using a DAW or a MIDI recording device that can
echo the incoming MIDI data back to the PolyBrute.
12.8.6. MIDI: Program change
Use [Assign 1-2] to make a selection. ON enables the PolyBrute keyboard to send and receive
bank/program changes. OFF prevents this data from being sent or received.
Arturia - User Manual PolyBrute - Settings 97