12.2.3. Voice: LFO
LFO 1 and LFO 2 have identical features, so they are described together. The Sync Division
options for all three LFOs are identical, so they are described together. LFO 3 has a Retrig
switch so its polarity options are described in a separate section.
12.2.3.1. LFO1/LFO2 global retrig
• An LFO set to Mono mode is shared by all voices. Retrig On/Off controls if the
mono LFO will retrigger when a new note is played. When Retrig = ON, the mono
LFO will retrigger; When Retrig = OFF, the mono LFO will
not
retrigger.
• Use [Assign 5-6] to choose the polarity option [p.27] for the LFO.
12.2.3.2. LFO3 polarity
• Use [Assign 5-6] to choose the polarity option [p.27] for LFO 3.
12.2.3.3. LFO1-3 sync division
The Sync Division settings are the same for all three LFOs. The [Sync] button must be active
for an LFO or this setting will make no difference.
86 Arturia - User Manual PolyBrute - Settings
To Next Page
Loading...
