TD 92674EN
29 April 2015 / Ver. I
Configuration Manual
Ascom d81 DECT Handset
11
4. Maintenance
TIP: Several handsets of the same device type (d81) can be upgraded simultaneously using
the Baseline function in the Unite module. See the Installation and Operation Manual for the
Unite module.
4.3 View Handset License
The license(s) of a handset can be viewed as follows;
• In idle mode, press *#34# and select "License", or
• View the license(s) via the Admin menu in the handset, see 6.1 Admin Menu Tree on
page 62, or
• In the PDM, select the "Licenses" tab and select handset in the list. In the bottom of the
work area, the license options of the device are listed, and whether the options are
enabled or not.
4.4 Upgrade Handset by License
Tip: It is recommended to read the Function Description, Product Licensing Overview, TD
92677GB before reading this section. The document describes how to view current
license(s), purchase license(s) and the technical solution of the upgrading alternatives
described below.
A handset can be upgraded to Protector and new functionality by adding a license key for
the new functions or variant.
There are three alternatives for upgrading a handset:
• Automatic upgrade, see 4.4.1 Automatic License Upgrade on page 12.
• License upgrade using import/export, see 4.4.2 License Upgrade Using Import/Export on
page 12.
• Manual upgrade, see 4.4.3 Manual License Upgrade on page 13.
Note: A handset can be re-licensed up to 99 times.
The following functions are license dependent:
•Shared Phone
1
, see 5.44 Shared Phone on page 58 for additional settings.
•DECT Location, see 5.22 DECT Location and LF Location on page 33 for additional
settings.
• Bluetooth Data Profile, see 5.46 Bluetooth Data Profile on page 60 for additional
settings.
• Pull cord alarm, see 5.28 Pull-Cord Alarm on page 39 for additional settings
1. Only applicable if the handset is used in a IP-DECT system.
To Next Page
Loading...
Need help?
General
