TD 92674EN
29 April 2015 / Ver. I
Configuration Manual
Ascom d81 DECT Handset
22
5. Handset Configuration
5.7 Call Diversion
User friendly call diversion menus can be configured in the handset using PDM/Device
Manager. These menus can then be selected in the handset by selecting Calls > Call services
> Divert calls.
Tip: In addition to the default call diversion menus, up to define 10 extra system specific
services codes can be defined. See 5.6 Call Services.
1 Select Systems > System X (where X represents A - H).
2 Select PBX Settings > Diversion.
3 Select "Internal", "External", "On No Reply", "On Busy", and/or "All Calls"; enter the
following:
• Prefix - the system specific prefix code to be used (if required by the PBX used)
• Suffix - the system specific code required to activate the diversion (for example
"*21*")
• Cancel - the system specific code required to deactivate the diversion (for
example "#23#").
The user can now enter the diversion number in the handset.
5.7.1 Call Diversion in Profiles
A handset can be configured to divert calls when a certain profile is activated.
NOTE: The PBX settings for call diversion must also be configured, see 5.7 Call Diversion.
1 Select User Profiles > User Profile X > Presence and diversion.
2 Select which calls to be diverted (that is all call, internal calls etc.).
3In the Divert calls to field, enter the phone number where the calls are diverted to
when the profile is activated.
4 Select "User Profile X".
5In the Name field, enter an appropriate name of the profile.
Additional settings can be added for a profile, such as soft keys, sound and alert etc. See
5.42.1 User Profiles on page 53.
5.8 Absence Handling
User friendly absence menus can be configured in the handset using PDM/Device Manager.
These menus can then be selected in the handset by selecting
Calls > Call services > Absence.
This menu is used to set the reason why a call cannot be answered, for example when you
are in a meeting. The caller is notified about the absence reason when calling.
Beside the default absence menus, up to 10 extra system specific services codes can be
defined, see 5.6 Call Services.
1 Select Systems > System X (where X represents A - H).
2 Select PBX Settings > Absence.