ASCOM D81 Configuration Manual

TD 92674EN
29 April 2015 / Ver. I
Configuration Manual
Ascom d81 DECT Handset
49
5. Handset Configuration
5.32.1 Configure the Handset for Message Templates
To activate the message template function in the handset so that a user can decline a call
with a predefined message, perform the following steps using the PDM/Device Manager:
1 Open the "Edit parameters" dialog
2 Select Settings > Answering
3 Locate the parameter "Reject with a message template" and set the value to "On".
5.32.2 Create Message Template Texts
A handset can be configured with up to five predefined messages. A message cannot
exceed 50 characters. To create a message, performing the following steps in the PDM/
Device Manager:
1 Open the "Edit parameters" dialog
2 Select Settings >Messaging > Templates > Template <n> where n refers to the five
message templates numbered 1 to 5.
3 Click on a Template <n>.
4 Position the cursor in Value column and click the mouse button. An editable text field
is opened.
5 Type a message of maximum 50 characters in the text field.
6 Click the "OK" button.
NOTE: If a system uses a character set other than UTF-8 for SMS, care must be taken to
ensure that the characters entered into the message strings are compatible with the
character set used by the system. Entering characters that cannot be encoded by the
system may cause a type conversion error, the failure of the message to arrive at the
intended recipient, and a "Message failed" popup being displayed in the sender handset.
5.33 Services
From PDM/Device Manager, up to 10 services that can be reached from the Services menu
can be configured. Soft keys to access services quickly can also be configured. A list of
predefined functions are available such as Phone call, Send message etc.
5.33.1 Add Service
1 Select "Services".
2 Select the service (1 - 10) to be configured.
3In the Name field, enter the name of the service. It is displayed in the handset.
4In the Type drop-down list, select the function to be used.
5 If needed, in the Number field, enter the destination number for the message/call/
data. The following values can be entered in the Number field: Digits 0-9, #, *, P –
pause, H – hook.
TIP: If the Phone call function was selected, an additional character U can be entered
in the Number field. The handset prompts for user input. Numerical characters can be
entered before a call is established (procedure call).
6 If needed, in the Prefix field, enter the prefix to be used.

ASCOM D81 Specifications

General

Brand	ASCOM
Model	D81
Category	Handsets
Language	English