ASCOM D81 Configuration Manual

TD 92674EN
29 April 2015 / Ver. I
Configuration Manual
Ascom d81 DECT Handset
15
4. Maintenance
4.7 Replacement of Handset with Device Manager
Both the old handset and the new handset must be of the same device type. The same
extension number is assigned to the new handset.
Make sure that the old handset is saved in the Device Manager. Start the Device Manager
and navigate to the "Numbers" tab. There is a in the Saved column for the old handset.
If the handset is not saved, insert it into a desktop charger or charging rack connected to
Device Manager and perform a save, see the Installation and Operation Manual for the Unite
module.
If the old handset settings cannot be saved, stop the replacement procedure. Instead
unsubscribe the old handset from the PBX, register the new handset and follow the
instructions for installing a handset, see 3.2 Installing a New Handset on page 8.
When the handset is saved, unsubscribe the old handset from the PBX. The following steps
are described for two different scenarios. Check the most suitable before proceeding.
4.7.1 Data Included in a Replacement Transfer
The following data is replaced during a replacement with Device Manager:
• User parameters (including User ID)
• Contacts (entered by the user)
Note that the following data is not replaced:
•DECT registration
• Call list
• Messages
• Bluetooth pairing list
• Company phonebook
• Downloaded Language
•Licenses
1
4.7.2 Handset Replacement with Device Manager in DECT System
NOTE: The replacement handset must not have any previous valid registrations. If it has a
valid registration, unsubscribe the handset.
1 Unsubscribe the old handset. If the unsubscribtion cannot be performed in the
handset, unsubscribe the handset via the DECT interface. See the corresponding
documentation for your system.
2 Subscribe the new handset with the same extension number as the old handset. The
subscription procedure is described in the handset’s User Manual. During the
subscription procedure, the handset’s User ID is automatically set to be the same as
the extension number.
TIP: The User ID can be viewed in the handset by navigating to the menu:
Admin menu > Device info > User ID.
1. A handset’s license can be moved using the Move license function in the Device Manager.

ASCOM D81 Specifications

General

Brand	ASCOM
Model	D81
Category	Handsets
Language	English