ascon S2 Series - Page 36

Sigmadue - microPAC MP-01 - User manual
28
4-2 I/O Watch Window
Figure 4.2 - I/O Watch Window
Using the “ I/O Watch Window ” the user can:
• Read the analogue inputs in engineering format;
• Read the digital inputs in binary format;
• Set the analogue output values in percentage (0...100);
• Set the digital outputs in binary format;
• Read the temperture values from the connectors (used for the cold
junction compensation in case of TC input) and from the internal board
(internal use only).
The window is updated continuously in order to allow the user to test the I/O
connected to the unit. The refresh rate can be adjusted using the following table:
To set an output value, the user must select the output number (1 for the digital,
2...5 for the analogue output) and then specify the desired value:
- A percentage (0...100%) for the analogue (without regard tor the output type);
- A digital value for the digital.
Examples: Digital Output Channels
Analogue Output Channels
Ch1 Output Type: 0...10V
Desired value: 7.00 V
Enter selection: 2
Insert new value: 70.00
Ch2 Output Type: 4... 20 mA
Desired value: 12 mA
Enter selection: 3
Insert new value: 50.00
Value Refresh rate
0 No refresh (static mask)
1...5 Time between 2 refresh sessions (1... 5 seconds)
I/O WATCH
12345678
DI: 00000000
1. DO: 00000000
2. AO CH1 (Volt): 0.00
3. AO CH2 (Volt): 0.00
4. AO CH3 (Volt): 0.00
5. AO CH4 (Volt): 0.00
AI UNIVERSAL
CH1: Not Present
CH2: Not Present
AI HIGH LEVEL
CH1: 2.50 V
CH2: 2.50 V
CH3: 2.50 V
CH4: 2.50 V
CH5: 2.50 V
CH6: 2.50 V
CH7: 0.00 V
CH8: 0.00 V
T1: 31.4 Celsius
T2: 34.0 Celsius
Ascon S.p.a.
SigmaPAC micro Control Unit MP-01
Device configuration
6. Expansion 1 Watch Window 7. Expansion 1 Watch Window
8. Autorefresh (0..5): 1
Enter selection:
Digital Output DO 1 DO 2 DO 3 DO 4 DO 5 DO 6 DO 7 DO 8
Desired value 00100011
Enter selection 1
Insert new value 00100011