ascon S2 Series User Manual

Sigmadue - microPAC MP-01 - User manual
22
Note: Please note that for both optional universal input channels the setup menu is the
same as described here.
3-2-14 Local AI Universal Pot Cal Menu
Figure 3.21 - Local AI Universal Pot Cal Menu
Due to the fact that the potentiometer input must be calibrated in the field, the necessary
operations are performed using this menu. The following steps are required:
1. Enter in the menu of the channel where the potentiometer is connected
(see
“Setup the Selected AI Universal Channel” on page 21 );
2. Select Channel Input Type as Potentiometer (value 15);
3. Enter in Calibration Potentiometer menu using the item 8;
4. Set a Refresh command using the item 2. The system will answer with
“
Ready for cal hi ”;
Channel Input
Type
13 Thermoresistance PT100
-200°C (-328°F)(73K) 1372°C (2501°F)(1645K)
14
Thermoresistance PT1000
-200°C (-328°F)(73K) 850°C (1562°F)(1123K)
15 Potentiometer
0.00 100.00
Temperature
Unit
In case of temperature measurement this item allows the user to select the desired
measurement unit
Possible values are:
Value Unit
0°C
1°K
2°F
Cold Junction
Compensation
In case of Thermocouple measurement this item allows the user to activate or
deactivate the internal cold junction compensation
Possible values are:
Code Active compensation
0No
1Yes
Read Value Input value read
Refresh Refresh command to update the “Read Value” item
Frequency
Rejection
Set the power rejection filter
Possible values are:
Code Rejection frequency
050 Hz
160 Hz
Calibration
potentiometer
Potentiometer Calibration Menu
Exit Return to previous menu
LOCAL AI UNIVERSAL POT CAL MENU
Channel: 0
Action: Press Refresh
1. Exec
2. Refresh
4. Exit
Enter Selection:
Ascon S.p.a.
Sigma microPAC Control Unit MP-01
Device configuration

ascon S2 Series Specifications

General

Brand	ascon
Model	S2 Series
Category	Controller
Language	English