Machinery Technical File Reference: ASG-TF-SD2500-01
EMC Technical File Reference: ASG-TF-SD2500-EMC-01
Information on Noise Emission
The ASG Division of Jergens Inc., Model SD2500 Electric Screwdriver Sound Pressure and Sound Power Levels
per EN ISO 11202 are as follows:
Serial No: As noted on Nameplate
Year of Construction: 2015
L
pAm
(Bystander Position)
Peak C-weighted instantaneous SPL in the Operator’s position
Sound power emitted where the equivalent continuous A-weighted
SPL exceeds 80 dB (A).
The average difference between the extraneous noise level and the
sound power level at each measuring point:
Ambient Correction Factor K3A calculated according to EN ISO 11204
Appendix A.
Measurements were made at a height of 1.5 m and 1 m from the Operator Position and all four sides of the
equipment.
The figures quoted are emission levels and are not necessarily safe working levels. While there is a correlation
between the emission and exposure levels this cannot be used reliably to determine whether or not further
precautions are required.
Factors that influence the actual level of exposure of the workforce include characteristics of the work room,
the other sources of noise, etc. such as the number of machines and other adjacent processes. Also, the
permissible level of exposure can vary from country to country.
This information, however, will enable the user of the machine to make a better evaluation of the hazard and
risk.
ASG, Division of Jergens Inc.
15700 S. Waterloo Rd.
Cleveland, Ohio 44110 USA
Information on Transmitted Vibration
To Next Page
