Page 7
The ASG Division of Jergens Inc., Model SD2500 Electric Screwdriver transmitted vibration levels as
found according to EN ISO 60745 are as follows: Screwdriver vibration: < 2.5 m/s
2
Safety Precautions
Be sure to read all instructions and precautions contained in this manual, failure to do so may result in
personal injury and/or damage to tooling and components.
DAMAGE REQUIRING SERVICE – Unplug this product from the wall outlet and request servicing by
qualified service personnel under the following conditions:
o When the power supply cord is damaged
o When the tool cable is damaged
o If liquid has been spilled onto the enclosure of the unit.
o If the product does not function normally by following the instructions in the User’s Guide. Adjust only
those controls that are covered by the operating instructions. Improper adjustment of the controls may
result in damage and will often require rework by a qualified technician to restore the product to its
normal operation.
o If the product has been damaged in any way.
o When the unit displays a negative, distinct change in performance.
Do not operate or plug in the controller/system with wet hands or in wet environments. Failure to observe
this may result in injury due to electric shock.
Do not operate this equipment from any power source that does not match the voltage rating marked on
the equipment. Refer to the Manufacturer’s Identification Label for operational requirements.
Ensure the controller is properly plugged in to a grounded electrical receptacle. Do not remove the
ground pin or use any adapter plugs.
To Next Page
Loading...