Ashida ADR111A - Page 96

Doc ID : ADR111A_IM_01
Ref ID : ADR111A/IM/UG
Rev No. : 04
Page No. : 96 of 127
ADR111A /
ADR211A
CT Pri =500 so that when 1A current flows into relay circuit, in
measurement window it will show you 500A).
Press the left arrow Key () to move to the next option.
Trip Cont = 002
SR = 1 HR = 2
Editable Setting
By using the Plus / Up arrow key (+ /) or the Minus / Down
arrow key (- /) the desired Trip Contact can be selected. i.e.
1 or 2. In which, 1 corresponds with SR (Self-Reset) and 2
correspond with HR (Hand-Reset) respectively.
Press the left arrow Key () to move to the next option.
BF Cont = 002
SR = 1 HR = 2
Editable Setting
By using the Plus / Up arrow key (+ /) or the Minus / Down
arrow key (- /) the desired BF Contact can be selected. i.e. 1
or 2. In which, 1 corresponds with SR (Self-Reset) and 2
correspond with HR (Hand-Reset) respectively.
Press the left arrow Key () to move to the next option.
Com Port = FRONT
FRONT/REAR
Editable Setting
By using the Plus / Up arrow key (+ /) or the Minus / Down
arrow key (- /) the desired Com Port can be set i.e. FRONT /
REAR
Press the left arrow Key () to move to the next option.
Parity = None
None/Even/Odd
Editable Setting
By using the Plus / Up arrow key (+ /) or the Minus / Down
arrow key (- /) the desired Parity can be set i.e. None / Even
/ Odd
Press the left arrow Key () to move to the next option.
Baud Rate = 003
Range 1 – 5
Editable Setting
By using the Plus / Up arrow key (+ /) or the Minus / Down
arrow key (- /) the desired Baud Rate can be set.