Asiga MAX - Post-processing Printed Parts; Removing Parts from Build Platform; Part Washing Procedure

Asiga MAX User Guide
Copyright ASIGA © 2017 VERSION 1.04
CHAPTER 6
Post-processing Parts
Parts build on the MAX need to be removed from the build platform, washed and post-
cured.
Removing Parts from the Build Platform
Use a metal scraper or razor blade to remove parts from the build platform.
Washing Parts
Resin residue remaining on printed parts can be removed by washing in isopropanol. Best
practice for efficient use of isopropanol is to maintain two baths: a “dirty bath” and a “clean
bath”.
First wash the parts in the dirty bath. This removes the majority of the resin residue.
Then move the parts to the clean bath. This removes the remainder of the resin residue.
After the clean bath has been used for some time the resin can be transferred to the dirty
bath and fresh isopropanol added to the clean bath.