Asko TD60 - TD60.1 Wiring Diagram

Servicemanual TD60
33
Wiring diagramTD60.1
This document must not be copied without our written pemission, and the contents thereof must not be imparted to a third party nor be used for any unauthorized purpose. Contravention will be prosecuted. Asko Appliances AB
CIRCUIT DIAGRAM TD60.1
80 820 34 - 01
NTC 1
EL 550W/1050W
INKB
BO
AP
NTC 2 *A
T1
T2
EL 1950W
CONNECTION BOX FOR USA & CANADA
L
N
L
L1 2
L1 2
L2 2
L2 2
L
RECL
N
RECL
RECG
INKB
DB
FB
*A
*A
WIRES IN ALL MACHINES
WIRES IN SOME MACHINES
*A CONDENSE DRYER
RESISTANCES AT ROOM TEMPERATURE (CA. 20°C/68°F) VALUES WITH +/-10% ARE REGARDED AS NORMAL COMPONENT F: RADIO INTERFERENCE SUPPRESSION FILTER 680K Ohm NTC 1: THERMISTOR 1 4 - 6 K Ohm NTC 2: THERMISTOR 2: 4 - 6 K Ohm AP: DRAIN PUMP: 111 Ohm EL: HEATING ELEMENT 550W 91.4 Ohm EL: HEATING ELEMENT 1050W 45.3 Ohm EL: HEATING ELEMENT 1950W 20.5 Ohm MO: MOTOR T1: THERMOSTAT, OVERHEATING (HEATER) T2: THERMOSTAT, FAN HOUSING FB: FLOAT SWITCH DB: DOOR SWITCH
AP
F
L N
M
TOTAL RESET TURN OFF POWER (S1) WAIT FOR AT LEAST 5 SEC HOLD STOP (S11) TURN ON POWER (S1)
CABLE POSITIONS 1: THERMISTOR 4: MOTOR, DRAIN PUMP, FLOAT SWITCH 5: DOOR SWITCH 8: POWER 9: HEATING ELEMENT
2009-09-03
S4
S10
S11
S1
S3
S7
S9
SERVICE MENU TURN OFF POWER (S1) WAIT FOR AT LEAST 5 SEC HOLD S10 TURN ON POWER (S1) PRESS S10 5 TIMES TO ENTER SERVICE MENU PRESS STOP (S11) TO CHANGE MENU STEP ROTATE DIAL TO CHANGE IN STEP PRESSING START (S10) STORES AND EXITS SERVICE MENU