Servicemanual TD60
34
Rehanging the door
Instructions Image
1. Remove the plinth by carefully pulling it
out.
2. Remove both screws for the lower hinge.
Use Torx.
3. Push the door upwards with care and
angle outwards. If necessary, carefully press
the lower hinge to detach the door.
4. Slacken off the lower and upper hinge
pins using a fixed spanner.
5. Remove the plastic plugs covering the
holes for the hinge pins and switch location
The tumble dryer (only certain models) is supplied with the door hung on the right-hand side. It is, however, pos-
sible to re-hang it according to the instructions below. Take care not to damage the paint when carrying out work
with tools.
Required tools
Flathead screwdriver
Torx size 20
Fixed spanner size 8
To Next Page
Loading...
