Asko TD60 - Page 35

Servicemanual TD60
35
Method for removing plastic plugs, lock
and catch located on the machine and
the door:
Carefully push the plug, catch or lock
upwards with a flat screwdriver. as the
picture shows.
6. Carefully remove the catch and plastic
plug on the door and switch location.
7. Carefully remove the lock and plastic
plug on the machine and switch location.
8. Screw the hinge pins securely into
place on the corresponding side of the
machine.
9. Slacken off the screws for the lower
hinge on the corresponding side of the
machine. This must be done to hang the
door.
10. Align the door in the upper hinge.
Carefully push the lower hinge down if
necessary and align the door.
11. Screw the lower hinge into place
securely. Use Torx.