with the Barcode reading, and user can enter the quantity immediately after reading the Barcode.
The quantity can be entered from 1 to 9999, and other barcodes cannot be read until the quantity
of the corresponding barcode is entered. The currently set items are marked with ‘*’.
4) Numbering : When the Barcode Data is captured, the number of recognized Barcode Data is
displayed on the screen including the sequence number in front of the Barcode Data. When user
clear the memory, it starts over from 1.
5) Terminator : This is a function to set the delimiter to be added to the end of the data when
transmitting captured data in HID mode to the host device connected to the AT388. It can be set
among LF, CR, CR & LF, tab, space, semicolon, and None.
• LF <0x0a> : Recognized data is output and the cursor moves to the next line.
• CR <0x0d> : Recognized data is output and a space as much as ‘Space’ is appended to the
end of the data.
• CRLF <0x0d+0x0a> : Recognized data is output and the cursor moves to the next line after
‘Space’ is added to the end of the data.
• Tab <0x09> : Recognized data is output and a space as much as ‘Tab’ is appended to the end
of the data.
• Space <0x20> : A space as much as ‘Space’ is appended to the end of the recognized data.
• SemiColon <0x3B> : Recognized data is output and ‘;’ at the end of the data. It sticks.
• None : Outputs data continuously without attaching anything to the end of the data.
6) UHF Report (UHF only) : Set whether to transmit PC (Protocol Control) data when transmitting
UHF RFID Tag Data.
7) BARCODE IDs (Barcode only) : Set the ID format of Barcode Data. User can select either SYMBOL
ID or AIM ID. The ‘ID’ item must be selected in ‘Device Setting Mode → 4. Data Format → 1.
Recode’ for this function to be applied.
8) ASCII29 Setup : This is a function to change ‘ASCII 29’ included in Barcode Data to ‘ASCII 126’ and
display it on the screen or transmit it to the host device.
9) User Memory : If this option is set, data in the User Memory area of Tag can be read in HID mode.
• User Inv Mode : Determines whether to use User Memory Data Reading option.
• User Offset : Set the starting point for User Memory Data Reading. (Default : 2 (word))
• User Length : Set the length of data when reading User Memory Data. (Default : 9 (word))
To Next Page