35
A
B
C
D
E
F
G
J
K
L
M
O
S
T
U
V
W
X
Y
A Icon START programmed cycle (press and hold
for more than 3 seconds)
B
2-digit display, indicates the selected program
(Note: the display ashes when a parameter has
been modied);
C
2-digit display, indicates the functions (parame-
ters) of the selected program and progress during
the cycle
D
3-digit display, indicates the value of the function
displayed and the current height of the carriage
during the cycle
E Resets the alarms and stops the buzzer
F
Press and hold to lift the carriage manually
G Press and hold to lower the carriage manually
J Cursor for increasing and decreasing values
K RESET the machine cycle
L
Value increase icon
M Value decrease icon
O STOP cycle icon, the machine slows down and
stops instantly; the cycle can continue from the
same point
S
"Copy" icon, copies the values of the functions of
the selected program. When pressed, the display
P starts ashing and CPY appears on display V
to indicate that a copy and paste operation is in
progress; press the icons P+ and P- to select the
target program; press the T icon to paste the set of
functions in the selected program, or press RE-
SET to exit without saving the parameters in the
target program
T "Paste" icon, pastes the values of the functions in
the selected program (see above).
U
"Reload" icon, reloads the saved values of the
selected program
V
Save parameters
W Disable keypad icon
X Functions
Y Displays the battery charge
To Next Page
Loading...
