Atlanta SFERA - Page 37

37
•
•
•
•
Signals
The LED right of the display F indicates the writing
protection status of the selected programme. If turned
on, it is not possible to rewrite the modied parameters.
It is necessary to select the parameter F00 on the same
programme to carry out modications and set the value
1 in the parameter, and then hold down RESET for at
least 3 seconds. If the programme is to be saved and
at the same time blocked in writing, after saving it, set
1 in parameter F00 (padlock open) and then 0 again
(padlock closed) and then save
Indication of the weight of lm consumed (Opt)
The machine indicates the weight of lm consumed at
the end of each cycle. "CF" appears on display F and
the amount of lm used for the last wrapping cycle, in
grammes, is shown on display V. (note: in order to ensure
good precision, set the correct thickness of the lm in
parameter F24).
Screen calibration
With the machine in alarm mode, press any point of the
screen for a few seconds
"Pt" appears on display F while "rEL" is shown on display
V, indicating not to touch the screen until the counter on
display P reaches zero;
Next, touch in sequence these 4 points:
• Top left
• Top right
• Bottom right
• Bottom left
After each touch, display P counts back from 4 to 1.
When this is done, "End" appears on display V to
indicate successful completion, otherwise the 'EFC'
alarm is triggered.
The machine then restarts automatically.
触控面板校正
当机器在故障模式，按压触控面板上任何一点几秒
接下來，依照以下4点顺序点击触控面板
左上角
右上角
右下角
左下角
不要触摸面板，知道显示屏P计数至零；
之后每点击一下，显示屏P从4到1计数。
当操作完成时，显示屏V显示'End'表示成功，
否则会显示故障码'EFC'，表示不成功。
然后机器会自动才重新启动。
胶膜消耗重量指示(选购功能)
每次包装行程结束时，可以指示胶膜所消耗重量
显示幕F出现'CF'
信号
LED显示屏F显示选定包装程式的写入保护状态。
如果打开将不可覆写修改的参数，如果需要覆写功
能F00参数值需设定1，然后按住复位键RESET至少
3秒。这时候所修改的参数将被储存，之后的储存
修改都是设置参数F00为1(解锁)0(上鎖)。
钟'PT'出现在显示屏F，显示屏V出现'rEL'，这时