MT Focus 6000 EN Settings
© Atlas Copco Industrial Technique AB - 9839 0527 01
11
Description
Reset Batch sequence Resets the selected Bach sequence.
Inc./dec. Batch sequence Increases/decreases one step in the batch sequence
Increment/decrement Batch Increases/decreases the progress of the batch
counter.
Import/Export via USB
Data can be exported or imported to/from a connected USB flash drive.
Description
Export results / Export and clear results Exports all results to a .csv-file and removes the re-
sults from the controller memory.
Export graphs / Export and clear graphs Exports all graphs to a .mtg-file and removes the
graphs from the controller memory. Graphs can be
opened from TollsTalk MT > Analysis.
Export configurations Exports all configurations to an offline file that can be
opened by ToolsTalk MT.
Export software Exports the software.
Export events Export all events to a .csv.file.
Export all Exports all data.
Import configurations Imports an offline file from a connected USB flash
drive.
It is not possible to import a configuration file on a
tightening controller that was made for a QA con-
troller and vice versa.
Import software Imports software from a connected USB flash drive.
Configuration
Description
Controller information Show detailed information on the controller.
Battery information Show detailed information about the connected bat-
tery.
Information is only available if battery is con-
nected with RS232 and the parameter Battery
adapter enabled is set to Yes.
Transducer information (Licensed feature)
Show detailed information about the connected trans-
ducer.
Tool information Show detailed information on the connected tool.
Connection information Show detailed information on connected devices, such
as ToolsNet, USB, Open protocol and Fieldbus.
IP configuration Settings to view and edit the IP configurations.
To Next Page
Loading...
